User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-42
When the filenames have been entered, click the Upload button
to commence loading the firmware file. If the upload is successful, a
message informs you that it was successfully loaded and asks you to
reboot the device. Go to the Save & Reboot page and perform a
simple reboot. If the firmware does not load, an error message
informs you to try the upload again. Check the filenames and attempt
to upload again. If the file still will not load, reboot the device and try
again.
Caution:
Do not power off the MT800 during its rebooting. Otherwise, the configuration in the
flash could be damaged.
To Next Page
Loading...
