OPERATION MANUAL
V1.3.0en/06.07.15//14.06 Liability for errors and misprints excluded. CC®
6.1.2.2 USB-2.0 interface, device ........................................................................... 71
6.2 Cooling/heating baths: Interfaces at the back ............................................... 71
6.2.1 Activation connector ....................................................................................... 71
6.3 Cooling/heating baths: Interfaces on the hanger thermostat ........................ 71
6.3.1 Service interface ............................................................................................. 72
6.3.2 RS232 (option) / activation of cooling bath .................................................... 72
6.3.3 Connection jack for Pt100 process control sensor ......................................... 72
6.4 Firmware update .......................................................................................... 72
7 Service/maintenance 73
7.1 Messages from the temperature control unit ............................................... 73
7.2 Electrical fuse ............................................................................................... 73
7.3 Replacing the “Pilot ONE®” ........................................................................... 73
7.4 Maintenance ................................................................................................ 74
7.4.1 Function check and visual inspection ............................................................. 74
7.4.2 Clean liquefier fins (air-cooled temperature control unit) ............................. 75
7.4.3 Clean hat-type strainer (dirt trap) (water-cooled temperature control unit) . 76
7.5 Thermal fluid inspection, replacement and circuit cleaning ........................... 77
7.5.1 Thermal fluid inspection ................................................................................. 77
7.5.2 Cleaning the thermal fluid circuit .................................................................... 77
7.6 Cleaning the surfaces ................................................................................... 79
7.7 Inspect the mechanical seal .......................................................................... 79
7.8 Plug contacts ................................................................................................ 79
7.9 Decontamination/repairs ............................................................................. 79
8 Shutting down 80
8.1 Safety instructions and basic principles ........................................................ 80
8.2 Switch-off .................................................................................................... 81
8.3 Packing ........................................................................................................ 81
8.4 Shipping ....................................................................................................... 81
8.5 Disposal ....................................................................................................... 82
8.6 Phone number and company address ........................................................... 82
8.6.1 Telephone number: Customer Support .......................................................... 82
8.6.2 Telephone number: Sales ............................................................................... 82
8.6.3 Email adress: Customer Support ..................................................................... 82
8.6.4 Service/return adress ...................................................................................... 82
8.7 Certificate of Compliance ............................................................................. 82
9 Annex 83
To Next Page
Loading...
