Function description
Chapter 3 OPERATION MANUAL
V1.3.0en/06.07.15//14.06 Liability for errors and misprints excluded. CC®
3.9.3 Restore factory settings
Use this function to reset the temperature control unit to various basic states. This is useful if you
want to reverse various settings relatively quickly.
Restoring the factory settings is only possible if the temperature control unit is not carrying out a
task. If a task is active, do not switch off the temperature control unit until the application allows
this. Restoring the factory settings cannot be revoked. Depending on the type of resetting to facto-
ry settings performed you may have to enter parameters (process safety, thermal fluid used, cut-
out value etc.) again.
= value is reset
= value is not reset
Description
Standard value
Unit Control Data
without OT
Your setting
Acoustics On
Display functions
- Warnings Manual acknowledge
- Messages Manual acknowledge
- Inactive menu options Show
- Resolution Temperature
0.01 K (with CC
“Basic”: 0.1 K)
Display modes
Unistat: Graphics;
CC: Normal
AutoStart response Off/Standby
Limits
- Delta T limit 100 K
- Max. heating variable 100 %
- Max. cooling variable 100 %
- Max. permissible power
draw (230 V machines)
Not defined (is que-
ried at the start of
Pilot ONE)
Com.G@te (only if
Com.G@te is connected)
- Analogue interface
Config. input
- Meaning AIF input Input off
- Response on cable break Trigger alarm
- Setting measurement range -40 °C … 100 °C
- Calibration No calibration
- On error, analogue Cut-out
- Current/voltage switchover Current
- Filter constants 2
Config. output
- AIF output variable No output
To Next Page
Loading...
