Shutting down
Chapter 8 OPERATION MANUAL
V1.3.0en/06.07.15//14.06 Liability for errors and misprints excluded. CC®
8.2 Switch-off
PROCEDURE
>Mains switch< [37] set to “0”.
Disconnect the temperature control unit from the power supply.
8.3 Packing
Use the original packaging wherever possible! Further information can be found on page 22 in sec-
tion »Unpacking«.
8.4 Shipping
Temperature control unit transported in a horizontal position
DAMAGE TO THE COMPRESSOR
Only transport the temperature control unit in an upright position.
Temperature control unit transported incorrectly
PROPERTY DAMAGE
Do not transport by truck on the castors or feet.
Comply all requirements in this section to avoid damage to the temperature control unit.
Transport using the lugs, if fitted, on the top of the temperature control unit. Do not transport the
temperature control unit alone and without aids.
▪ Always use the original packaging for transport.
▪ Always transport the temperature control unit upright on a pallet!
▪ Protect attachments from damage during transport!
▪ During transport, place the temperature control unit on squared timber to protect the cas-
tors/feet.
▪ Secure with tensioning belts/lashing straps rated for the weight concerned.
▪ Additionally secure (depending on model) with plastic film, cardboard and straps.
Pallet with squared
timber for free-
standing units
To Next Page
Loading...
