Normal operation
Chapter 5 OPERATION MANUAL
V1.3.0en/06.07.15//14.06 Liability for errors and misprints excluded. CC®
5.2 Cooling/heating baths: Automatic operation of K1x and K2x
(without hanger thermostat)
5.2.1 Cooling/heating baths: K1x and K2x thermoregulation
5.2.1.1 Cooling/heating baths: K1x and K2x start thermoregulation
The temperature control process can be started after filling and complete venting.
PROCEDURE
Switch on the cooling bath using the >mains switch< [37] (Position “I” continuous operation).
The maximum cooling capacity of the cooling bath is permanently available in "continuous oper-
ation" (Position "I" of the >mains switch< [37]).
5.2.1.2 Cooling/heating baths: K1x and K2x stop thermoregulation
When the temperature control unit is switched off, the thermal fluid temperature is high-
er/lower than room temperature
DAMAGE TO THE TEMPERATURE CONTROL UNIT AND THE GLASS APPARATUS/APPLICATION
Bring the thermal fluid up to room temperature using the temperature control unit.
Do not close the shut-off valves in the thermal fluid circuit.
The temperature control can be ended at any time, the pump continues to run for approx. 30 sec-
onds.
PROCEDURE
Switch off the cooling bath using the >mains switch< [37] (Position “0”).
Positions of the
>mains switch< [37]
on K1x and K2x
To Next Page
Loading...
