Function description
OPERATION MANUAL Chapter 3
CC® Liability for errors and misprints excluded. V1.3.0en/06.07.15//14.06
Description
Standard value
Unit Control Data
without OT
Your setting
- Setting output range -40 °C … 100 °C
- Calibration No calibration
- RS232/RS485
Hardware RS RS232
Baud rate 9,600 Baud
Device address 1
- ECS Standby No impact
- POKO alarm Off
Attributes (other)
- Change thermal fluid
Thermal fluid No data
No. of liters 0
Use of bypass No
- Chilling bath/cooling (CC-E
only)
None
Sensor calibration
Automated compressor Permanently on
Enter program No program present
Pump settings
- Setpoint pump speed
Unistat: max. speed
3,500 l/min.
CC: 2,500 l/min.
- Setpoint pump pressure 500 mbar
- Control mode Speed control
Controller parameterization
- Select auto/manual
Automatic control
parameters
- Configuration auto
Control dynamics Fast, small overshoot
Controller parameter
Dependent on Sim-
File, no general values
Fluid attributes
- Thermal fluid No data
- No. of liters 0
- Use of bypass No
- Configuration manual pa-
rameters
Change control parameters
- Internal KP 200
To Next Page
Loading...
