Chapter 2 • Uninstalling your current remote terminal
4
1037076-0001 Revision C
Uninstalling a DW4000
The process of uninstalling a DW4000 consists of the following
tasks:
• Removing Internet connection sharing (ICS) software from
your computer (if you are not using ICS, you can skip this
task)
• Removing DIRECWAY software from your computer
• Disconnecting the indoor receive unit (IRU) and indoor
transmit unit (ITU) stack from your computer
Removing ICS software
from your computer
Determine which operating system is installed on your computer
and select the appropriate procedures to remove the ICS software
from the computer:
Windows XP on page 4
Windows 2000 on page 4
Windows 98 SE on page 5
Windows Me on page 5
Windows XP 1. Open My Computer or Windows Explorer.
2. Right-click My Network Places and select Properties.
3. Highlight each Local Area Connection until you find the one
that is listed as the Satellite Receiver Adapter.
4. Right-click on the Local Area Connection that corresponds to
the Satellite Receiver Adapter and click Properties. The
Local Area Connection Properties dialog appears.
5. Select the Advanced tab and Click Settings.
6. At the Windows Firewall General tab, select ON and check
the Don’t Allow Exceptions check box.
7. Click OK to close the Windows Firewall dialog.
8. Click OK to close the Local Area Connection Properties
dialog.
Windows 2000 1. Click Start
→
Settings→ Network and Dial-up Connections.
The Network and Dial-up Connections dialog box appears.
2. Highlight each Local Area Connection until you find the one
that is listed as the Satellite Receiver Adapter.
3. Right-click on the Local Area Connection that corresponds to
the Satellite Receiver Adapter and click
Properties.
4. At the dialog that appears, select the Sharing tab.
5. Uncheck the check box next to Enable Internet Connection
Sharing for this connection
.
6. Click OK.
7. Close the Network and Dial-up Connections window.
To Next Page
Loading...
Need help?
General