Chapter 2 • Uninstalling your current remote terminal
1037076-0001 Revision C
5
Windows Me 1. Click Start
→
Settings→ Control Panel.
2. Double-click the Add/Remove Programs icon. The
Add/Remove Programs screen appears.
3. Select the Windows Setup tab. The Windows Setup screen
appears.
4. Highlight Communications and click Details.
5. Uncheck the check box next to Internet Connection Sharing.
6. Click OK.
7. Return to the Windows Setup tab.
8. Click OK.
9. Restart the computer.
Windows 98 SE 1. Click Start
→
Settings→ Control Panel.
2. Double-click the Add/Remove Programs icon. The
Add/Remove Programs screen appears.
3. Select the Windows Setup tab. The Windows Setup screen
appears.
4. Highlight Internet Tools and click Details.
5. Uncheck the check box next to Internet Connection Sharing
and click OK.
6. Return to the Windows Setup tab.
7. Click OK.
8. Restart the computer.
Uninstalling DIRECWAY
software from your
computer
When your DW4000 was installed, DIRECWAY software was
also installed on your computer. You must remove this software
from your computer before installing your new HN7000S
terminal. Follow these steps to remove the software:
1. Locate the USB cable that connects the IRU to your
computer. See
Figure 2.
2. Detach the USB cable from the IRU and the computer.
3. On your computer, go to Start→ Programs
→
DIRECWAY
→
Uninstall.
4. Click Ye s on the message confirming that you want to
uninstall DIRECWAY.
Status messages reporting on the progress of the software
removal appear.
5. Reboot your computer if instructed to do so. Ignore or click
through any error messages.
To Next Page
Loading...
Need help?
General