Chapter 2 • Uninstalling your current remote terminal
8
1037076-0001 Revision C
.
5. Detach the coaxial cable from the SAT IN connector on the
DW6000/DW7000 remote terminal. If the connector is too
tight to remove by hand, loosen it with a 7/16-inch wrench. If
the connector is warm, let it cool first.
6. Label the cable with a tag or small piece of electrical tape
with the words satellite in on it.
7. Detach the coaxial cable from the SAT OUT connector on the
DW6000/DW7000 remote terminal. If the connector is too
tight to remove by hand, loosen it with a 7/16-inch wrench. If
the connector is warm, let it cool first.
8. Label the cable with a tag or small piece of electrical tape
with the words satellite out.
9. Dispose of the DW6000/DW7000 remote terminal. See
Disposing of the old remote terminal on page 2 for
information on disposal and recycling. Do not return the
remote terminal to Hughes. Do not discard the power
supply or cords.
10. Proceed to Chapter 3.
Figure 3: Uninstalling a DW6000/DW7000
AC power
cord
Ethernet
cable
SAT IN
Power
supply
DC power cord
LAN 2
DC IN
LAN
Ethernet
SAT OUT
To Next Page
Loading...
Need help?
General