Chapter 3 • Installing the HN7000S remote terminal
1037076-0001 Revision C
11
Using the Activation
Software CD
.
The HN7000S shipping carton contains a HughesNet Activation
Software compact disc (CD). The activation software verifies that
your PC meets certain hardware and software requirements and
automatically configures the PC for the HughesNet service. Use
the Activation CD as follows:
1. Make sure your PC is not connected to a network.
2. Insert the Activation CD into your PC’s CD-ROM drive.
3. Select the checkbox to accept the software license
agreement.
Note: If you do not have a HughesNet Activation Software CD,
you must manually configure your PC for use with the HN7000S
remote terminal. Skip this section and proceed to
Disabling web
browser proxy settings on page 13.
Note: If the activation software determines that your PC
does not meet the minimum requirements and it cannot
correct this situation, it will instruct you to contact Customer
Care for assistance.
Note: If you do not accept the license agreement, you
cannot proceed with the upgrade.
To Next Page
Loading...
Need help?
General