Chapter 3 • Installing the HN7000S remote terminal
30
1037076-0001 Revision C
4. Click Next.
5. On the screen that appears, verify that the city and state for
the zip code you entered is correct and click Next.
The registration process begins. The system establishes a
connection with the satellite, then downloads and verifies
your encryption keys. During this process, status messages
appear on the Registration in Progress screen.
6. Click Next when prompted to do so, then click OK on the
popup message that appears to access the Registration server.
7. Read the HughesNet Subscriber Agreement and click I
Agree to accept the terms.
Refer to your confirmation email and enter your site account
number (SAN) and personal identification number (PIN) in
the fields provided on the Registration screen as shown in
Figure 26.
Note: If the antenna location information is not correct,
click
Back to return to the previous screen and re-enter your
zip code.
Note: Depending on your computer’s security settings, you
may see a Security Warning Alert. Click
Ye s to
continue/bypass the message.
Note: If you do not agree to the Subscriber Agreement, you
cannot proceed with the upgrade.
To Next Page
Loading...
Need help?
General