1-9: General Information General Information: 1-8
Never allow water to freeze inside the truckmount. Serious component damage
will occur. Perform all freeze guarding procedures outlined in this digital Owner’s
Manual.
Many vehicles have critical components mounted directly below the oor that can
easily be damaged. Before drilling holes in the oor of the vehicle inspect the
underside of the vehicle for critical components. Failure to do so may result in
damage to the vehicle.
Use of the vacuum recovery system when stripping or otherwise removing wax
from oors is specically excluded as an approved use of the truckmount. Failure
to follow this exclusion may lead to component failure and will invalidate your
warranty.
Use of the vacuum recovery system for “dry cleaning”, without corresponding
solution application (i.e. duct cleaning), is specically excluded as an approved
use of the truckmount. Failure to follow this exclusion may lead to component
failure and will invalidate your warranty.
If concentrated acids or solvents are used to pre-treat surfaces before power
washing, do not recover them through the vacuum system. Failure to follow this
exclusion may lead to component failure and will invalidate your warranty.
RESPONSIBILITIES
Purchaser’s Responsibilities
• Prior to purchasing a van, ensure that the payload is suitable for all of the equipment
that will be installed and transported. This includes and is not limited to: the truckmount,
recovery tanks, fresh water tanks and any other on-board water hose reels, hoses,
cleaning tools, chemicals and drying equipment. Payload capacity information is
available through the auto dealer, the manufacturer’s web site, and is also located on
the door pillar of the driver’s side door.
• Purchase a heavy duty Group 24 (500+ CC Amps) battery for this truckmount. This is
normally available from the installation dealer.
• Prior to dropping your van off at the distributor for the truckmount to be installed, have
a spray-on bed liner applied to the oor such as Rhino Lining® or Line-X®.
Plywood and carpet are not recommended.
• Prior to operating the truckmount, read this manual in its entirety and familiarize
yourself with the information contained here. Special attention should be paid to all
Warnings and Cautions.
• The distributor is responsible for the correct installation of the truckmount. The
distributor is also responsible to train you in the correct and proper operation and
maintenance of the truckmount.
Any modication of the truckmount may void the warranty.
To Next Page
Loading...