1-13: General Information General Information: 1-12
MACHINE SPECIFICATIONS
Frame Dimensions 24”W x 31”H x 36”D
Weight 563 lbs
Engine 23HP Briggs and Stratton air-
cooled
Pressurized Oil System Engine Oil:
5W-30 Synthetic
Capacity Approx. 1 1/2 quarts, or
48 oz (when changing
oil and lter)
Engine rpm 3,000 rpm
Fuel Consumption 1.1 gph
Ignition Electric Keystart
Vacuum Blower -
Tuthill 4005
Oil Type Blower Oil:
Pneulube
Gear End Capacity Approx. 5.8 oz
Drive End Capacity Approx. 4.7 oz
Blower rpm 3,000 rpm
Water Pump -
General Pump
4.0 gpm Plunger Pump, Electric
Clutch Control
Pump Oil:
GP Series 100
Drive System Direct-drive Hayes 40-series
Coupler
Engine Exhaust Diverter Automated Diverter Control
(ADC) Temperature Control
Operating Pressure 1,000 psi
Chemical System Stainless Steel Last-Step
Chemical Injection, Meter
Controlled
Heating System Finned Tube Heat Exchanger
Standard Equipment Runtime Hour Meter
Chemical Flow Meter (0-10
Gph)
Chemical Flow Control Valve
Vacuum Gauge (0-30" Hg)
Solution Pressure Gauge
(0 - 1,500 Psi)
Solution Pressure Adjustment
Pre-Wired Pump-In Switch
Pre-Wired APO Switch
Fresh Water Inlet
Water System Drain Valve
Diagnostic/Status Lights
Engine Choke
Engine Throttle
Electrical Circuit Protection
(Fuse Protected)
Solution Temperature Control
Selector
Available Equipment Fresh Water Tank (FWT) 70 Gallon Rotomold
Universal Recovery Tank (URT) 70 Gallon URT
100 Gallon URT
Automatic Pump Out (APO)
Hoses
Wand
Thru Floor Kit
To Next Page
Loading...