DynaMAX 550P/560P/575P Waterjet Pump Operator Manual 811390 13
Product stewardship
Hypertherm maintains a global regulatory management system to make sure that products comply
with regulatory and environmental requirements.
National and local safety regulations
National and local safety regulations shall take precedence over instructions supplied with the
product. The product shall be imported, installed, operated, and discarded in compliance with
national and local regulations applicable to the installation site.
Certification test marks
Certified products are identified by 1 or more certification test marks from accredited testing
laboratories.
The certification test marks are on the pump’s data plate.
Each certification test mark means that the product and its safety-critical parts conform to the
national safety standards as reviewed and determined by that testing laboratory.
Hypertherm puts a certification test mark on its products only after that product is manufactured
with safety-critical parts that have been approved by the accredited testing laboratory.
Once the product has left the Hypertherm factory, the certification test marks are invalid if one or
more of these events occurs.
The product is modified in a manner that causes danger or does not conform with the applicable
standards.
Safety-critical parts are replaced with unapproved spare parts.
To Next Page
Loading...
Need help?
General
