Hypertherm DynaMAX 550P User Manual

Preventive maintenance
4
96 811390 Operator Manual DynaMAX 550P/560P/575P Waterjet Pump
10. Engage the intensifier.
Intensifier
Every 500 hours
• Repair the check valve and the low pressure
poppets.
• Repair the high-pressure cylinders.
• Replace the high-pressure seal cartridges.
Every 1,000 hours
• Replace the high-pressure poppet assemblies.
• Replace the low-pressure poppets.
Every 1,500 hours
• Flip the high-pressure cylinders.
Every 3,000 hours
• Replace the high-pressure cylinders.
• Replace the check valve assemblies.
Every 6,000 hours
• Replace the output adapters.
• Replace the seal housing assemblies.
Every 6,000 hours
• Replace the spacer tubes.
• Repair the hydraulic center section.
CAUTION
To prevent causing damage or premature failure, use 2 wrenches when loosening or
tightening a high-pressure connection.
Always tighten fittings to the specified torque.
CAUTION
Do not use an adjustable wrench on high-pressure fittings.
Use clean hands when changing high-pressure parts.
To reduce downtime, Hypertherm recommends doing preventive maintenance on both
ends of the intensifier at the same time.

Hypertherm DynaMAX 550P Specifications

General

Brand	Hypertherm
Model	DynaMAX 550P
Category	Water Pump
Language	English