Safety
22 811390 Operator Manual DynaMAX 550P/560P/575P Waterjet Pump
Safety information for operation, maintenance, repair, and installation
Also refer to Symbols and marks on page 25.
DANGER
Before opening the electrical enclosure or doing maintenance or repairs on this equipment,
turn
OFF the electrical power and release water pressure and hydraulic pressure from the
system.
Use standard lock out–tag out procedures.
Isolate all sources of electrical, mechanical, hydraulic, pneumatic, chemical, thermal, or other
energy with a lockable energy-isolating device that satisfies national and local requirements.
WARNING
Make sure that all connections, fasteners, locking devices, hoses, and fittings are tight before
operation.
WARNING
Make sure that the shaft access cover and all other safety devices are correctly installed
before operating this machine.
WARNING
Do not stand in line with high-pressure fittings when operating this equipment.
If a high-pressure fitting fails, it can cause a stream of water or hydraulic fluid to eject from the
system with force.
WARNING
Do not leave waterjet cutting equipment unattended while it is operating.
WARNING
During operation, keep a restricted-access area clear that is larger than the maximum
movement range of the cutting equipment’s moving parts.
WARNING
Let only approved personnel operate this machinery.
WARNING
Release all high-pressure water before doing work on this equipment.
WARNING
HOT SURFACE
Do not touch.
To Next Page
Loading...
Need help?
General
