The operation panel turns the control circuit in the pump on and off and controls local and remote
pump operation.
1LOCAL-REMOTE key switch
When the key switch is in the L
OCAL
position, use the operator interface to
operate the pump.
When the key switch is in the R
EMOTE
position:
• Use the remote source, such as a
computer numerical control (CNC)
operator console, to control the
pump.
• Most of the functions on the operator
interface are not available.
Refer to Operate the pump remotely on page 58.
2CONTROLS ON button
Push this button to turn
ON the control circuit in
the pump. The button lights when the control
circuit is on.
3E
MERGENCY STOP button
When this button is pushed:
• The control circuit turns off, which turns off
the pump, the primary motor, and the
intensifier.
• The bleed-down valve opens to release
high-pressure water from the system.
Refer to Emergency stop on page 60.
4R
EMOTE indicator light
When the L
OCAL-REMOTE key switch is in the
R
EMOTE position, this indicator light is on.
To Next Page
Loading...
Need help?
General
