Preventive maintenance
DynaMAX 550P/560P/575P Waterjet Pump Operator Manual 811390 73
2. Empty the container, if necessary
3. Make sure the drip tray is empty and clean.
4. To remove the tray, push down on the tab until the tray releases. Pull the tray toward you.
5. To install the tray, put the rear edge of the tray between the stud and the high-pressure cylinder.
Push up on the tray tab until the tray makes a click.
6. Make sure that all warning decals are visible and legible.
7. Contact Hypertherm for replacement decals.
8. Clean the operator interface, if necessary.
Gently wipe the touchscreen and keys with a clean microfiber cloth.
Use a cleaner made for touchscreens or use a 1:1 solution of distilled water and white
vinegar.
Do not pull the tray out fully. There are 2 tubes attached to the rear of the tray that
must be disconnected first.
To prevent damage to the operator interface:
Do not use cleaners that contain alcohol, ammonia, acetone, phosphates, or ethylene
glycol.
Do not push hard on the touchscreen.
Do not use paper towels, abrasive cloth, or dirty rags.
Do not put liquid directly onto the touchscreen.
Do not scratch the surface.
To Next Page
Need help?
General
