Hypertherm DynaMAX 550P User Manual

Preventive maintenance
4
DynaMAX 550P/560P/575P Waterjet Pump Operator Manual 811390 87
Do this task when the pump is off.
1. Disconnect a tube by pulling the tube away from the clip.
2. Disconnect the tube from the push-to-connect fitting on top of the SMI by pushing up on the
collar of the fitting while pulling down on the tube.
3. Use the tube cleaning brush to clean the inner surfaces of the tube.
.
4. Rinse the tube with clean water.
5. Connect the tube to the push-to-connect fitting on top of the SMI.
6. Push the tube into the clip.
7. Do this procedure for all 4 tubes.
Before cleaning After cleaning

Hypertherm DynaMAX 550P Specifications

General

Brand	Hypertherm
Model	DynaMAX 550P
Category	Water Pump
Language	English