Hypertherm Powermax65 SYNC Reference Guide

Serial Communication Programmer Reference Guide
Powermax65/85/105 SYNC Reference Guide 810400 65
Figure 5 – CNC reads and sets permitted cut mode, amperage, and gas pressure
SET
PARAMETERS
BY ?
SYNC AUTOMATICALLY SETS
MODE, CURRENT, AND PRESSURE
TO CARTRIDGE NOMINAL
CNC CUSTOM CUT MODE,
CURRENT, PRESSURE
WRITE MODE , CURRENT,
AND PRESSURE
REGISTER WRITE 0x3080-0x3082
TO ENTER REMOTE CONTROL MODE
DETERMINE NEXT CUT MODE,
AMPS AND PRESSURE
BY CUT CHART, OPERATOR
INPUT, OR G-CODE
VERIFY NEXT AGAINST
CARTRIDGE CAPABILITY
CHECK FOR
FAULT.
REGISTER READ
0x0298
ALLOW
CYCLE START
RESOLVE
FAULT
WRITE CUT MODE.
REGISTER WRITE 0x2093
WRITE SET CURRENT.
REGISTER WRITE 0x2094
WRITE SET PRESSURE.
REGISTER WRITE 0x2096
READ CARTRIDGE CUT MODE AND
MIN/MAX CURRENT AND
PRESSURE.
REGISTER READ 0x3001-0x3005
DETERMINE NEXT CUT MODE, AMPS
AND PRESSURE BY CUT CHART,
OPERATOR INPUT, OR G-CODE
VERIFY NEXT AGAINST MIN/MAX CAPABILITY
TO ENTER REMOTE
CONTROL MODE
READ CURRENT SET LOW AND HIGH.
REGISTER READ 0x2099 AND 0x209A
READ PRESSURE SET LOW AND HIGH.
REGISTER READ 0x209C AND 0x209D
CHECK FOR
FAULT.
REGISTER READ
0x0301A
ALLOW
CYCLE START
MINOR OR
MAJOR ?
BEST PRACTICE / AUTOMATIC
OLDER
SYNC
ENTERENTER
READ CARTRIDGE PN.
REGISTER READ 0x3038-0x303B
POWER SUPPLY
OR MAJOR FAULT
MINOR FAULT,
OPERATION
ALLOWED
FAULT
DETECTED
NO FAULTS
0-00-0
POWER SUPPLY
OR MAJOR FAULT
FAULT
DETECTED
NO FAULTS
0-00-0
FIX THE PROBLEM
FIX THE PROBLEM
MINOR FAULT,
OPERATION
ALLOWED

Hypertherm Powermax65 SYNC Specifications

General

Brand	Hypertherm
Model	Powermax65 SYNC
Category	Welding System
Language	English