CUT NOT ALLOWED UNTIL USER
ACTION
USER
ACTION
POWERMAX DEFAULTS TO 45A,
CUT MODE, SYSTEM PRESSURE
CHANGE A
SETTING
ADDITIONAL TRIGGER PULLS
NO PUFFS, NO ARC.
CUTTING IS STILL NOT ALLOWED
0-14-0 REMAINS
1ST TRIGGER PULL, WARNING
PUFFS OF AIR, NO ARC
PULL
QUICK RESTART USING
THE MAIN POWER
SWITCH
INSTALL A DIFFERENT
CARTRIDGE
EXIT
ENTER
OTHER FAULT CODES REMAIN
0-14-1
OR 0-98-1
OR 0-98-2
CUT IS ALLOWED
EXIT
OTHER ACTIONS TO RETRY
READING THE CARTRIDGE
MOVE THE LOCK SWITCH
TO THE UNLOCKED
POSITION
MOVE THE LOCK SWITCH
TO THE LOCKED THEN
UNLOCKED POSITION
SET MODE AND AMPS
FROM THE SYNC
FRONT PANEL
FAULT CODE 0-14-0
CARTRIDGE CANNOT SEND
DATA TO THE POWER SUPPLY
SYNC - HAND TORCH (CLEAR THE FAULT OR SET PARAMETERS MANUALLY)
TRIGGER
To Next Page
Loading...
