Hypertherm Powermax65 SYNC Reference Guide

Serial Communication Programmer Reference Guide
Powermax65/85/105 SYNC Reference Guide 810400 77
Figure 17 – (Mech/mini) Cartridge cannot send data to the power supply (fault 0-14-0)
CUT NOT ALLOWED UNTIL USER OR
CNC INTERVENTION
USER
ACTION
INSTALL A DIFFERENT
CARTRIDGE
ADJUST MODE AND AMPS
FROM THE SYNC
FRONT PANEL
POWERMAX DEFAULTS TO 45A,
CUT MODE, SYSTEM PRESSURE
FAULT CODE REMAINS
OR 0-14-1
OR 0-98-1
OR 0-98-2
CUT IS ALLOWED
CHANGES A
SETTING
MINI/ROBOTIC TORCH
QUICK RESTART USING THE
MAIN POWER SWITCH OR
CNC COMMAND.
SEE NOTE BELOW.
IF IN REMOTE MODE,
SET MODE AND AMPS
FROM THE CNC
USING SERIAL COMMANDS
EXIT
EXIT
ENTER
MINI/ROBOTIC TORCH
0-14-1
OR 0-98-1
OR 0-98-2
MOVE THE TORCH LOCK
TO THE UNLOCKED
POSITION (DOWN)
MOVE THE LOCK SWITCH
TO THE LOCKED THEN
UNLOCKED POSITION
OTHER ACTIONS TO RETRY
READING THE CARTRIDGE
NOTE: MINI/ROBOTIC TORCHES DO NOT HAVE A LOCK SWITCH.
DO A QUICK RESTART OF THE POWER SUPPLY AFTER CHANGING A CARTRIDGE.
FAULT CODE 0-14-0
CARTRIDGE CANNOT SEND
DATA TO THE POWER SUPPLY
SYNC - MECH/MINI (CLEAR THE FAULT OR SET PARAMETERS MANUALLY)

Hypertherm Powermax65 SYNC Specifications

General

Brand	Hypertherm
Model	Powermax65 SYNC
Category	Welding System
Language	English