EasyManuals Logo

IAI ssel User Manual

IAI ssel
497 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #344 background imageLoading...
Page #344 background image
318
Part 3 Positioner Mode
* To perform push-motion or interpolation operation, turn ON the applicable input signal before turning
ON the start input signal. Turn the operation signal OFF after the start input signal has turned OFF.
* While the actuator is moving to the target position, only the pause or cancellation input is accepted.
The servo cannot be turned off even if the servo ON input signal is turned OFF. (The servo can be
turned off only when the positioning complete output signal is ON.)
* While the start input signal is ON, the positioning complete output signal will not turn ON even after the
actuator physically completes moving to the target position. Therefore, always turn OFF the start input
signal ([4]) to detect the completion of positioning.
* As for the positioning complete output signal and push-motion complete output signal, they will not be
output until the start signal turns OFF (based on the I/O control handshake rules).
* For the actuator to operate upon start signal input, the servo ON input signal must be ON. If the servo
ON input signal is OFF, these operation commands will not be accepted. Note, however, that only the
commands will be ignored and no error will generate.

Table of Contents

Other manuals for IAI ssel

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IAI ssel and is the answer not in the manual?

IAI ssel Specifications

General IconGeneral
BrandIAI
Modelssel
CategoryController
LanguageEnglish

Related product manuals