NO
If the drives do not power up, go to Step 8. If the drives power up, but with status LEDs reporting an error condition,
follow the recommended drive service action as appropriate (refer to the drive descriptive chapters).
YES
Go to Step 11.
Step 8
This step performs a visual and physical check in an attempt to fix the problem.
1. Prepare the 7226 Storage Enclosure for Service. See Preparing the 7226 Storage Enclosure for Removal or Installation
of a Storage Device or Other Component for the correct procedure.
2. Open the 7226 Storage Enclosure for Service. See Opening the 7226 Storage Enclosure for Service for the correct
procedure.
3. Visually inspect all of the internal components in the enclosure. Look for any signs of wear, damage, contamination, or
excessive heat. Replace any component that appears to be damaged.
4. Physically check each cable connection and ensure all cables are fully seated and secured.
Are their any signs of damage, wear, or loose cables?
NO
Plug the enclosure into an electrical source and press the power switch to determine if the connection inspection fixed
the problem. If the enclosure does not power up normally, go to Step 10. If the enclosure powers on and appears to run
normally, reassemble the enclosure, and then return to Step 1.
YES
Replace the damaged component or reseat the cable, reassemble the enclosure and then return to Step 1.
Step 9
This step checks the enclosure power as the possible source of the problem.
1. Press the power switch to turn off the power to the 7226 Storage Enclosure.
2. Disconnect the power cables from the Tape Drives, SAS Interface Assemblies, and RDX Docking Stations.
3. Connect the power cable to both the 7226 Storage Enclosure and to the electrical outlet.
4. Press the power switch to turn on the power.
Does the 7226 power up?
NO
Replace the enclosure (see Replacing an Enclosure), and then return to Step 1.
YES
Reattach the power supply cables to the Tape Drives, SAS Interface Assemblies, and RDX Docking Stations. Then go to
Step 10.
Step 10
This step examines the drives as the possible source of the problem.
1. Press the power switch to turn off the power to the 7226 Storage Enclosure.
2. Disconnect the power connector from the drive in Bay A.
3. Press the power switch to turn on the power.
Does the drive in Bay B power up and complete the Power On Self Test (POST) normally?
NO
To Next Page
Loading...
Need help?
General
