To Next Page

To Previous Page

and press Enter. The command lists all of the SATA devices that are connected to the host system. Figure 2 shows an

example of the screen that displays. The screen lists:

1 Device name 3 System address

2 Device Status 4 Description of the device

Figure 2. Screen Display of SATA Devices Attached to the host system

4. To see the installed USB device status, at the system prompt, type

#lsdev

and press Enter. The command lists all of the devices that are connected to the host system. Figure 3 shows an example

of the screen that displays. The screen lists:

1 Device name 3 System address

2 Device Status 4 Description of the device

Figure 3. Screen Display of USB Devices Attached to the host system

5. From the list of devices, identify the 7226 Storage Enclosure drive features. These are listed as:

SAS 4mm Tape Drive

SATA DVD-RAM Drive

USB 4mm Tape Drive

USB Mass Storage

Note: "USB Mass Storage" refers to the RDX Removable Hard Disk Cartridge Feature

SAS 1/2-inch Cartridge Tape Drive

IBM LTO Ultrium Tape Drive (FCP)

IBM LTO Ultrium Tape Drive (SAS)

If the status of the 7226 Storage Enclosure drive feature is displayed as Available, the device has successfully been

conﬁgured.

If the status is not displayed as Available, refer to Troubleshooting. For more information about conﬁguring the 7226

Storage Enclosure to the system software, refer to your AIX or host system manuals.

Is the 7226 storage enclosure properly conﬁgured to the host system?

Go to Step 16 (IBM Power System with AIX Operating System Only).

YES

Go to Step 16 (IBM Power System with AIX Operating System Only) to verify that the problem is ﬁxed.

Step 16 (IBM Power System with AIX Operating System Only)

This step runs the AIX diagnostics to determine the problem or to verify a ﬁx.

1. Press the power switch to turn on the power.

2. Press the load/unload button to eject any media currently loaded in the devices.

3. Obtain the appropriate test media for the device. Inspect the test media for damage and debris. If the quality of the test

media is questionable, replace it with new test media.

4. Load the test media into the drive.

Note: For the preceding step, use only the test media; do not substitute with other media.

5. Run the diagnostics on the 7226 Storage Enclosure. For instructions, refer to your AIX manuals.

Do all of the diagnostic routines pass?

IBM 7226 Model 1U3 Storage Device Enclosure 265

IBM 7226 Manual

Other manuals for IBM 7226