IBM P 615 series

Yes Go to “Step 154B-8.”
Step 154B-8
Turn off the power.
Step 154B-9
Ensure that the power is off on the base system drawer.
Step 154B-10
Attention: Before replacing the processor backplane, call for support.
Replace the processor backplane at U0.1-P1, if not already replaced.
Step 154B-11
Turn on the power.
Step 154B-12
Did the system stop with the same error code as recorded in “Step 154B-1” on page 128?
No The card just replaced was defective. This ends the procedure.
Return the system to its original configuration.
Go to ″MAP 0410: Repair Checkout″ in the RS/6000 Eserver pSeries Diagnostic Information for
Multiple Bus Systems.
Yes Go to “Step 154B-13.”
Step 154B-13
Turn off the power.
Step 154B-14
Call for support. This ends the procedure.
Chapter 3. Maintenance Analysis Procedures (MAPs) 129