IBM P 615 series

1
2
3
5
4
1 Power Supply Bay Chassis
Bracket
4 System Chassis (Shown in Service Position)
2 Blue Thumbscrew 5 Hex-Head Screw (7)
3 System Backplane (Shown
with Voltage Regulator
Modules Attached)
Replacing the System Backplane
To replace the system backplane (system board), do the following:
1. Before handling any card, board, or memory DIMM, be sure to use your electrostatic discharge strap
to minimize static-electric discharge. Refer to “Handling Static-Sensitive Devices” on page 280.
2. If necessary, remove the system backplane from the antistatic package.
3. Carefully grasp the system backplane by the attached mylar handles.
4. Lower the system backplane at an angle, with the rear of the backplane connecting with the system
chassis first.
5. Slide the system backplane towards the rear of the system chassis, and align it with the alignment
pins on the chassis floor.
362 EserverpSeries 615 Service Guide