IBM P 615 series User Manual

Bezels
The following procedures describe the removal and replacement of the system bezel. Before performing
the following procedures, read “Safety Notices” on page xi.
Removing the Model 6C3 Front Bezel
To remove the front bezel, do the following:
1. Open the front rack door.
2. Press in on both bezel-release tabs at the same time.
3. Tip the bezel forward and gently pull the bezel up and away from the system.
1
2
3
4
1 Model 6C3 Front Bezel 3 Bezel-Release Tab
2 System-Retaining
Thumbscrew
4 System Drawer Release Latch
Replacing the Model 6C3 Front Bezel
To replace the front bezel, do the following:
1. Open the rack front door.
2. Seat the two tabs located on the bottom edge of the bezel into their mating slots located on the bottom
edge of the system.
3. Pivot the bezel up, aligning the release tabs to the mating slots located on the front of the system.
4. Gently push the tabs into the slots until the bezel seats against the front of the system.
5. Close the front rack door.
Chapter 9. Removal and Replacement Procedures 291

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English