IBM P 615 series

Quick Entry MAP
Quick Entry MAP Table of Contents
Problem Description Page No.
Service actions 56
The rack indicator LED does not operate as expected. 56
The system attention LED on the operator panel is on. 56
OK does not appear in the operator panel display before pressing the power-on button.
Other symptoms appear in the operator panel display or LEDs before the power-on
button is pressed.
56
8-digit error codes 57
System stops with an 8-digit number displayed 57
System stops with a 4-digit number displayed that does not begin with 0 or 2. 57
System stops with a 3-digit number displayed (see below for 888 sequence). 57
Hardware Management Console (HMC) Problem 57
There appears to be a display problem (distortion, blurring, and so on) 58
Power and cooling problems 59
888 sequence in operator panel display 59
Other symptoms or problems 59
Attention: If you replace FRUs or perform an action and the problem is still not corrected, go to “MAP
1540: Problem Isolation Procedures” on page 110 unless you were directed to MAP 1540 by the error
code. Otherwise, call for support if the actions for an error code do not resolve the problem.
If you replace FRUs or perform an action, and the problem is corrected, go to ″MAP 0410: Repair
Checkout″ in the RS/6000 Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Note: If the only service actions you perform are on the HMC, do not use MAP 0410 to do the repair
checkout.
Chapter 3. Maintenance Analysis Procedures (MAPs) 55