IBM P 615 series User Manual

Removing a Hot-Swap Disk Drive with the System Power Off
A hot-swap disk drive is removed from the system with the system power off when the system is running
Linux or a system failure has occurred.
Attention: Before you perform the following procedure, if your system is operational, back up the data
for the drive you are removing, and ensure that the drive has been removed from the configuration.
Physically removing a hot-swap drive from the system before it has been removed from the system
configuration can cause unrecoverable data corruption. Refer to “Deconfiguring a Disk Drive for Removal”
on page 333.
To remove a hot-swap disk drive with the system power off, see the illustration on page 336 and do the
following:
1. If the system is operational, stop the system as described in “Stopping the System” on page 282. If the
system is not operational, go to step 3.
2. Ensure all data on the disk has been saved.
3. On a Model 6C3, open the rack front door.
On a Model 6E3, open the front bezel door.
4. Locate the hot-swap disk drive you want to remove. Note the disk drive’s bay location so that it can be
replaced in the same slot.
5. Remove the disk drive by placing the disk drive release handle into the open position (perpendicular to
the drive) and pulling the hot-swap disk drive away from the bay. See the illustration on page 336
Replacing or Installing a Hot-Swap Disk Drive with the System Power
Off
A hot-swap disk drive is replaced or installed into the system with the system power off when the system
is running Linux or a system failure has occurred.
To replace or install a hot-swap disk drive with the system power off, see the illustration on page 336 and
do the following:
1. Install the disk-drive bezel as described in “Disk Drive Bezels and Fillers” on page 331.
2. Ensure the handle on the front of the disk drive is open (perpendicular to the drive).
3. Align the drive assembly so that it engages the guide rails in the bay.
4. Push the drive assembly into the bay until the drive handle engages the lock mechanism.
5. Push the disk drive handle in until it locks.
6. If the system is operational, start the system as described in “Starting the System” on page 283.
7. On a Model 6C3, close the rack doors.
On a Model 6E3, close the bezel door.
338 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English