IBM P 615 series User Manual

2. Click Close Event from this window. The Serviceable Event Comments window opens.
3. Click OK to commit your comments. The Update FRU Information window displays. For information on
completing this window, see “Updating Field Replaceable Unit (FRU) Information”. To close the
serviceable event, click OK on the Update FRU Information window .
Note:
You must close a serviceable event after it has been serviced to ensure that if a similar error is
reported later, it is called home. If an old problem remains open, the new similar problem is
reported as a duplicate. Duplicate errors are neither reported nor called home to a service
center. Close a serviceable event when the partition that reports the error is active. Closing the
event causes the new status of the serviceable event to be correctly sent to the partition.
Updating Field Replaceable Unit (FRU) Information
This task allows you to update the FRU information you changed or modified as a result of this serviceable
event. From this panel, you can also activate and deactivate LEDs and search for other serviceable events
that contain the same FRU entries.
To update FRU information, do the following:
1. Perform the steps in “Viewing Serviceable Event Details” on page 45.
2. Click FRU Information. The Update FRU Information window opens.
The lower table shows any parts that you have replaced or added during your current update session
but that have not been committed to the serviceable event. The changes from the lower table are
committed by clicking OK or Apply.
From
this window, you can also activate and deactivate LEDs and search for other serviceable events that
contain the same FRU entries.
Replacing an Existing FRU
To replace a part already listed for this serviceable event, do the following:
1. Perform the steps in “Updating Field Replaceable Unit (FRU) Information.”
2. In the upper table, double-click the part you want to replace.
3. If the FRU has a new part number, type it in the New FRU Part Number field.
4. Click Replace FRU. The Update FRU Information window displays the FRU replacement information in
the lower table. Click OK or Apply to commit the changes to the serviceable event.
Adding a New FRU
You can add a part to the serviceable event that was not listed in the upper table of the Update FRU
Information window. To add a new FRU for this serviceable event, do the following:
1. Perform the steps in “Updating Field Replaceable Unit (FRU) Information.”
2. Click Add New FRU.
3. Type the FRU’s location code and its part number in the appropriate fields.
4. Click Add to List. The Update FRU Information window opens and displays the newly added FRU in
the lower table.
5. Click OK or Apply to commit these changes to the serviceable event.
Note: After you click OK or Apply, you cannot change this information. If you clicked the Close Event
button in the Serviceable Event Details window, then clicking OK also completes the close
dialog and changes the status of the serviceable event to Closed.
Viewing Serviceable Event Partition Information
You can view partition information associated with this serviceable event. This information includes each
affected partition’s state and resource use.
1. Perform the steps in “Viewing Serviceable Event Details” on page 45.
2. Click Partition Information.
Chapter 2. Diagnostic Overview 47

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English