IBM P 615 series

Note: You must further configure Service Agent to handle notifications sent by Service Focal Point. For
more information about Service Agent, refer to the IBM Hardware Management Console Operations
Guide for pSeries, order number SA38-0590
To set up surveillance, you must be a member of one of the following roles:
v System Administrator
v Service Representative
To
set up surveillance-error notification, do the following:
1. In the Navigation area, click the Service Applications icon.
2. In the Navigation area, double-click the Service Focal Point icon.
3. In the Contents area, select Service Focal Point Settings.
4. The Service Focal Point Settings window opens. Select the Surveillance Notification tab at the top of
the window.
5. Select one or more managed systems from the list, and click Enable or Disable. Surveillance
notification is then either enabled or disabled for the selected managed systems.
Working With Serviceable Events
You can view, add, or update serviceable event information, including error details.
Viewing Serviceable Events
To view serviceable events, you must be a member of one of the following roles:
v System Administrator
v Service Representative
v Advanced Operator
v Operator
v Viewer
To
view a serviceable event, do the following:
1. In the Navigation area, click the Service Applications icon.
2. In the Navigation area, double-click the Service Focal Point icon.
3. In the Contents area, click Select Serviceable Event.
4. Designate the set of serviceable events you want to view. When you are finished, click OK.
5. The Serviceable Event Overview window opens, and the entries displayed are ordered by time stamp.
Each line in the Serviceable Event Overview window corresponds to one error within a serviceable
event. On this window, designate the set of serviceable events you want to view by specifying your
search criteria (such as event status or error class).
Note: Only events that match all of the criteria that you specify are shown.
6. When you are finished, click OK.
When
you select a line in the Serviceable Event Overview window, all lines in the same serviceable event
are selected. To open the Serviceable Event Details window for the selected event, select the event and
click Event Details.
Viewing Serviceable Event Details
To view serviceable event details, do the following:
1. Perform the steps in “Viewing Serviceable Events.”
2. The Serviceable Event Details window opens, showing extended serviceable event information,
including the following:
v Status
Chapter 2. Diagnostic Overview 45