IBM P 615 series

Bezel Door (Model 6E3)
The following procedures describe the removal and replacement of the bezel door.
Removing the Bezel Door
To remove the bezel door, do the following:
1. Open the bezel door by grasping the bezel door handle. Pull the bezel door out and away from the
system.
2. Press down on the top back edge of the door.
3. Gently swivel the top back edge of the door forward, out past the top of the system.
4. Lift the door up to release it from the lower retaining post.
2
6
5
7
4
1
3
1 Model 6E3 5 Bezel Door Handle
2 Bezel Door Post Hole 6 Bezel Door Release Tab
3 Bezel Door Top Retaining Post 7 Bezel Door Lower Retaining Post
4 Bezel Door
Replacing the Bezel Door
To replace the bezel door, do the following:
1. Set the bezel door on the lower retaining post. See the preceding illustration.
2. Rotate the bezel door toward the top of the system.
3. Press down on the back edge of the bezel door, and seat the top post into its mating hole.
4. Close the bezel door.
290 EserverpSeries 615 Service Guide