IBM P 615 series User Manual

Removing the Model 6E3 Front Bezel
To remove the front bezel, do the following:
1. Remove the bezel door as described in “Bezel Door (Model 6E3)” on page 290.
2. Press down on the two bezel-release levers.
3. Pull the top of the bezel out and away from the system.
4. Gently pull the bezel up and off the base, releasing the lower bezel locking tabs.
1
3
2
5
6
7
4
1 Model 6E3 5 Bezel Door Handle
2 Bezel-Release Levers 6 Lower Bezel Locking Tab (Quantity 2)
3 Front Bezel 7 Lower Bezel Retaining Slots (Quantity 2)
4 Front Door
Replacing the Model 6E3 Front Bezel
To replace the front bezel, do the following:
1. Place the two lower bezel locking tabs into the retaining slots located on the system base.
2. Rotate the bezel up toward the top of the system, ensuring that the aligning pins are aligned with their
mating holes located on the system.
3. Gently push the bezel in until the two bezel release levers are seated in their respective slots.
4. Replace the bezel door as described in “Bezel Door (Model 6E3)” on page 290.
292 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English