IBM P 615 series User Manual

3 = Complete
The dump will include as much information as possible to allow the complete analysis of hardware
and software errors.
4 = Minimum
The dump will include the smallest amount of information possible (a minimum number of
hardware scan log rings).
The complete dump will take the longest time to finish; it may take as long as 1.5 hours on a fully
configured system.
Option 3, Immediate Dump, can only be used when the system is in the standby state with power on. It is
used to dump the system data after a checkstop or machine check occurs when the system firmware is
running, or when the operating system is booting or running.
The scan log dump content can also be set from the Tasks menu in the AIX diagnostic service aids.
If a valid dump file already exists, the dump control code will stop because the contents of the prior dump
must be protected.
System Power Control Menu
This menu is used to set power control options. Other menus that control boot options are available from
this menu.
SYSTEM POWER CONTROL MENU
1. Enable/Disable Unattended Start Mode:
Currently Enabled
2. Ring Indicate Power-On Menu
3. Reboot/Restart Policy Setup Menu
4. Power-On System
5. Power-Off System
6. Enable/Disable Fast System Boot
Currently Fast Boot
7. Boot Mode Menu
98. Return to Previous Menu
99. Exit from Menus
0>
v Enable/Disable Unattended Start Mode
Use this option to instruct the service processor to restore the power state of the system after a
temporary power failure. Unattended start mode can also be set through the System Management
Services (SMS) menus. This option is intended to be used on systems that require automatic power-on
after a power failure. For more information, see “System Power-On Methods” on page 249.
v Ring Indicate Power-On Menu
Chapter 7. Using the Service Processor 235

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English