IBM P 615 series

– Go to the standby state (and the service processor menus will be available), indicated by OK or
STBY in the operator panel
OR
– Attempt to reboot.
Scan Log Dump Setup Menu
1. Scan Log Dump Policy:
Currently As Needed
2. Scan Log Dump Content:
Currently As Requested
3. Immediate Dump
98. Return to Previous Menu
0> 1
Select from the following options:
(As Needed=2, Always=3)
Enter New Option:
0>
The scan log dump policy can be set to the following:
2 = As Needed
The processor run-time diagnostics record the dump data based on the error type. This is the
default value.
3 = Always
Selecting this option allows the service processor to record a scan log dump for all error types.
The scan log dump policy can also be set from the Tasks menu in the AIX diagnostic service aids.
Option
2 displays the following screen:
Scan Log Dump Setup Menu
1. Scan Log Dump Policy:
Currently As Needed
2. Scan Log Dump Content:
Currently As Requested
3. Immediate Dump
98. Return to Previous Menu
0> 2
Select from the following options:
(As Requested=1, Optimum=2, Complete=3, Minimum=4)
Enter New Option:
0>
The scan log dump content can be set to the following:
1 = As Requested
The processor run-time diagnostics will select the contents of the dump file based on the type of
error that occurs. This is the default.
2 = Optimum
The dump will include the smallest amount of information to diagnose a hardware error.
234 EserverpSeries 615 Service Guide