IBM P 615 series User Manual

Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
E1D4 Create SCSI byte device node (ST) Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E1DB Create floppy controller (FDC) node Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E1DC Dynamic console selection.
1. If a console is attached, but nothing is
displayed on it, go to ″All display
problems″ in the Entry MAP.
2. If selection screens can be seen on the
terminals and the appropriate key on
the input device is pressed within 60
seconds but there is no response to the
keystroke:
a. If selecting the console with a
keyboard attached to the system,
replace the keyboard, then replace
the service processor,
Location: U0.1-P1-X1.
b. If selecting the console with an
ASCII terminal, suspect the
terminal. Use the problem
determination procedures for the
terminal.
Note:
Terminal setting should be:
v 9600 baud
v no parity
v 8 data bits
v 1 stop bit
E1F0 Start O.B.E. Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E1F1 Begin selftest sequence on boot devices. Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E1F2 Power-on password prompt The prompt should be visible on the
firmware console .
If a console is attached but nothing is
displayed on it, go to the “Quick Entry
MAP” on page 55 with the symptom ″All
display problems.″
E1F3 Privileged-access password prompt The prompt should be visible on the
firmware console (may be a VTERM on the
HMC).
If a console is attached but nothing is
displayed on it, go to the “Quick Entry
MAP” on page 55 with the symptom ″All
display problems.″
E1F4 End self-test sequence on boot devices;
begin SMS.
Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
E1F5 Build boot device list Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
Chapter 4. Checkpoints 145

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English