IBM P 615 series

Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
E851 Initializing RTAS/hardware access
1. Check for system firmware updates.
2. Call service support.
E852 Initializing RTAS/PCI bus interface
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
3. Call service support.
E853 Start cable ID request process
1. Remove, then reapply power to the
system.
2. Go to “MAP 1548: Processor
Subsystem Problem Isolation” on page
113.
3. Call service support.
E854 Start collecting cable IDs 1. Remove, then reapply power to the
system.
2. Go to “MAP 1548: Processor
Subsystem Problem Isolation” on page
113.
3. Call service support.
E860 Initializing RTAS/power subsystem interface
1. Check for system firmware updates.
2. Call service support.
E861 Initializing RTAS/PCI bus interface
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
3. Call service support.
E870 Initializing RTAS/logs interface
1. Check for system firmware updates.
2. Call service support.
E871 Initializing RTAS/EEH handling interface
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 110.
3. Call service support.
E872 Initializing RTAS/error inject interface
1. Check for system firmware updates.
2. Call service support.
E873 Initializing RTAS/error handling interface
1. Check for system firmware updates.
2. Call service support.
E880 Initializing RTAS/debug interface
1. Check for system firmware updates.
2. Call service support.
E881 Initializing RTAS/utility interface
1. Check for system firmware updates.
2. Call service support.
E882 Initializing RTAS/softpatch register interface
1. Check for system firmware updates.
2. Call service support.
E890 Initializing RTAS/hot-swap interface
1. Check for system firmware updates.
2. Call service support.
Chapter 4. Checkpoints 153