IBM P 615 series User Manual

Checkpoint or
Error Code
What You Should Do
8xxx
9xxx
Axxx
Bxxx
Service Processor Checkpoints
Go to “Service Processor Checkpoints” on page 133 for more information on these checkpoints.
A1FD 000x The system has entered recovery mode. Go to “Recovery Mode” on page 254.
B006 xxxx
B1xx xxxx
Common Firmware Error Codes
1. There may be additional error codes and information in the service processor error log. The
system must be powered off to examine the contents of the service processor error log.
a. Is the system still powered on?
NO Go to step 2 below.
YES Ask the customer if the system can be powered off, then go to step 1b below.
b.
Can the system be powered off?
NO Go to step 3 below.
YES Power off the system, then go to step 2 below.
2.
Confirm that this is the first error code that caused the failure as described in “Confirming Initial
Error Code” on page 159.
3. Did you come to this step from step 2?
NO Go to “Common Firmware Error Codes” on page 200 with the error codes you already
have and follow the instructions in the “Common Firmware Error Codes” on page 200
table.
YES Go to “Common Firmware Error Codes” on page 200 with the error codes from 2 and
follow the instructions in the “Common Firmware Error Codes” on page 200 table.
B3xx xxxx HMC Surveillance Error Codes
Go to “HMC Surveillance Error Codes” on page 214 for more information on these error codes.
Exxx Firmware Checkpoints
Go to “Firmware Checkpoints” on page 140 for more information on these checkpoints.
Mxxx xxxx Problem Determination-Generated Error Codes
Go to “Problem Determination Generated Error Codes” on page 215 and follow the instructions in
the Problem Determination Generated Error Codes table.
Chapter 5. Error Code to FRU Index 165

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English