IBM P 615 series

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
20D0 0A15 Error initializing interface/error injection access
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D0 0A16 Error initializing interface/handling access
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D0 0A17 Error initializing interface/utility access
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D0 0A18 Error initializing register softpatch access
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D0 9001 Subsystem information not found in VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D0 9002 Subsystem machine type and model information
not found in VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D0 9003 Subsystem serial number information not found
in VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D0 9004 Subsystem machine type and model field is
empty in VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D0 9005 Subsystem serial number field is empty in VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D0 9006 Duplicate subsystem serial number found in
VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D0 9007 Invalid subsystem machine type and model
information in VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D0 9008 Invalid subsystem serial number found in VPD
1. Power off, then power on the system.
2. If the error persists, call service support.
20D1 0001 Failed to send state-change message to service
processor
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 0002 Failed to disable heartbeat alarm
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
Chapter 5. Error Code to FRU Index 173