IBM P 615 series User Manual

Table 9. Common Firmware Error Codes (continued)
Error Code Description Action/
Possible Failing FRU
B1xx 4695 System power control network to service
processor interface failure
1. Check for system firmware updates.
2. Service processor
Location:
U0.1-P1-X1
B1xx 4696 System firmware interface failure
1. Check for system firmware updates.
2. Call service support.
B1xx 4698 Firmware problem
1. Check for system firmware updates.
2. Call service support.
B1xx 4699 Service processor firmware error or informational
message.
See B1xx 4699 in “Error Code B1xx 4699” on
page 209.
B1xx 469A System firmware interface
1. Check for system firmware updates.
2. Call service support.
B1xx 469B Firmware to I/O interface
1. Check for system firmware updates.
2. CEC backplane
Location:
U0.1-P1
B1xx 469C Firmware to I/O interface
1. Check for system firmware updates.
2. CEC backplane
Location:
U0.1-P1
B1xx 469E Service processor firmware failure
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 110
3. CEC backplane
Location:
U0.1-P1
B1xx 469F Service processor failure
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 110
3. CEC backplane
Location:
U0.1-P1
B1xx 8FF0 Informational message See B1xx 8FF0 in “Error Code B1xx 8FF0” on
page 212.
B1FD 0013 A firmware update has failed because the
update image is invalid. The update was stopped
before any changes were made to the currently
installed firmware.
Reset the service processor (by activating the
pinhole reset switch or by disconnecting, then
reconnecting power). Install a valid firmware
update image for the specific system type and
model.
B1FD 0015 Too many firmware update diskettes inserted (or
wrong or faulty update image)
1. Ensure the firmware update image is correct
for the specific system type and model.
2. Replace the update diskettes with a new set
of firmware update diskettes.
B1FD 0016 Diskette read error
1. The firmware diskette may be faulty. Try
another diskette.
2. Replace the diskette drive.
3. Replace the CEC backplane
Location: U0.1-P1
208 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English