IBM P 615 series

6. Before handling any card, board, or memory DIMM, refer to “Handling Static-Sensitive Devices” on
page 280.
7. Locate the service processor assembly as shown in the following illustration.
8. Grasp the ends of the service processor assembly handles, and press the retractable spring-activated
portion of each handle. This action releases the spring latch located on the bottom side of each
handle.
9. Lift the service processor assembly handles until they are perpendicular (90 degrees) to the top of the
assembly. By placing the handles perpendicular to the top of the service processor assembly, the
base or hinged portion of each handle acts as a cam and helps pry the service processor assembly
from its connector located on the system backplane.
10. Place the service processor assembly in a safe place.
Chapter 9. Removal and Replacement Procedures 313