IBM P 615 series User Manual

1. If you are servicing a Model 6C3, plug the operator panel cable into the media bay chassis as you
replace the media bay chassis in the system chassis.
Note:
If a sound cable is present, plug it into the appropriate connector at the rear of the SCSI media
device. For more information, see “Media Devices (Diskette, CD-ROM, DVD, DVD-RAM,or Tape
Drive)” on page 325.
2. Align the media bay chassis with the chassis opening and press into place until you feel the latches
lock.
3. Replace the front bezel as described in “Bezels” on page 291.
4. Reconnect all system power cables.
5. Return the system to the operating position as described in “Returning the Model 6C3 to the Operating
Position” on page 285 or “Placing the Model 6E3 into the Service and Operating Position” on page
286.
6. Start the system as described in “Starting the System” on page 283.
Chapter 9. Removal and Replacement Procedures 347

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English