Step 1540-13
Are there any adapters in slots 5, 6, or 7?
No Go to “Step 1540-14”.
Yes Go to “Step 1540-17” on page 125.
Step 1540-14
Are there any adapters in slots 9 or 10?
No Go to “Step 1540-15”.
Yes Go to “Step 1540-18” on page 125.
Step 1540-15
Are there any adapters in slots 11, 12, 13, or 14?
No Go to “Step 1540-22” on page 126.
Yes Go to “Step 1540-19” on page 125.
Step 1540-16
1. If it is not already off, turn off the power.
2. Remove all adapters from slots 1, 2, 3, and 4 that are not attached to the boot
device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power.
6. When the TTY screen displays Enter 0 to select this console, press the 0 key
on the TTY terminal’s keyboard.
Was the boot successful?
No Go to “Step 1540-13”.
Yes Go to “Step 1540-20” on page 126.
124 Service Guide
To Next Page
Loading...
