Serial Port Selection Menu
You can enable and/or disable the call-in and call-out functions of each serial port in
any combination from this menu:
Serial Port Selection Menu
1. Serial Port 1 Call-Out:
Currently Disabled
2. Serial Port 2 Call-Out:
Currently Disabled
3. Serial Port 1 Call-In:
Currently Disabled
4. Serial Port 2 Call-In:
Currently Disabled
98. Return to Previous Menu
1>
Note: For security, if the service processor detects an operator panel battery failure,
the serial port dial-in capability is disabled. See “Service Processor Call-In
Security” on page 471 for more information.
Serial Port Speed Setup Menu
Serial port speed can be set for terminal performance or to accommodate modem
capabilities using this menu:
Serial Port Speed Setup Menu
1. Serial Port 1 Speed:
Currently 9600
2. Serial Port 2 Speed:
Currently 9600
98. Return to Previous Menu
1>
A serial port speed of 9600 baud or higher is recommended. Valid serial port speeds
are as follows:
50 600 4800
75 1200 7200
110 1800 9600
134 2000 19200
150 2400 38000
300 3600 57600
115200
462 Service Guide
To Next Page
Loading...
Need help?
General