Adapter Parameters
Select the Adapter Parameters option from the Network Parameters menu to view an
adapter’s hardware address, as well as configure network adapters that require setup. A
screen similar to the following displays when you make this selection:
Adapter Parameters
Device Slot Hardware Address
1. Gigabit Ethernet 5: U0.1-P1-I5/E1 0004ac7c8628
2. ethernet 3: U0.1-P1-I3/E1 0060949d21db
3. token-ring 11: U0.1-P1-I11/T1 0004ac62a672
4. fddi 10: U0.1-P1-I10/Q1 00005a40aeff
.------.
|X=Exit|
′------'
(PRESS ENTER AFTER MAKING A SELECTION) ===>
Select an adapter on this screen to display configuration menus for that adapter. If
ethernet is selected, you can set parameters that control how the ethernet adapter
communicates with the network. For example, the following screen shows the menu for
the Ethernet adapter configuration:
1. Data Rate [Auto]
2. Full Duplex [No]
Selecting the Data Rate option allows you the change the media employed by the
Ethernet adapter:
.----------------.
| DATA RATE |
| 1. 10 Mbps |
| 2. 100 Mbps |
| 3. Auto |
′----------------'
===>
Chapter 8. System Management Services 483
To Next Page
Loading...
Need help?
General