IBM S85 pSeries 680 - Remote Initial Program Load Setup

Remote Initial Program Load Setup
This option allows you to enable and set up the remote startup capability of your
system. You must first specify the network parameters as shown in the following screen:
Network Parameters
1. IP Parameters
2. Adapter Parameters
3. Ping
.------.
|X=Exit|
′------'
===>
Note: Some applications may require that IP addresses contain leading zeroes for
numbers less than 100. For example, 129.132.4.20 may need to be entered as
123.132.004.020.
IP Parameters
Select the IP Parameters option from the Network Parameters menu to display a screen
similar to the following:
IP Parameters
1. Client IP Address [9.3.146.162]
2. Server IP Address [9.3.146.171]
3. Gateway IP Address [0.0.0.0]
4. Subnet Mask [0.0.0.0]
.------.
|X=Exit|
′------'
===>
To set an address using this menu, do the following:
1. Type the number of the selection (1, 2, 3, or 4).
2. Enter the address on the next screen.
482 Service Guide