IBM S85 pSeries 680 User Manual

Table 3. Firmware Checkpoints (continued)
Checkpoint Description Action/ Possible Failing FRU
E189 Add PS2 VPD to NVRAM and
device tree
See the note on page136.
E18A Request fan monitoring card VPD See the note on page136.
E18B Add fan monitoring card VPD to
NVRAM and device tree
See the note on page136.
E18C VPD and data communications with
I/O planar complete
See the note on page136.
E190 Create ISA node See the note on page136.
E191 Create ISA reserved node See the note on page136.
E193 Initialize Super I/O See the note on page136.
E196 Probe ISA bus See the note on page136.
E199 Reboot after flash Try to boot system a second time. If
this does not work, replace the I/O
planar.
See the note on page136.
E19B Create service processor node See the note on page136.
E19C Create tablet node See the note on page136.
E19D Create NVRAM node See the note on page136.
E19E Real-time clock (RTC) initialization Refer to error code 28030xxx in
“Firmware/POST Error Codes” on
page 159.
E1AD See description of checkpoint E1DE See the note on page136.
E1B0 Create lpt node See the note on page136.
E1B1 Create serial node See the note on page136.
E1B2 Create audio node See the note on page136.
E1B3 Create 8042 node 1. Replace the service processor
card.
Location: U0.1-P1-X1
AIX Location Code: 10-70 or
10-70 to 10-77 1E-xx
2. Go to “MAP 1540: Minimum
Configuration” on page 117.
E1B6 Probe for (ISA) keyboard 1. Replace keyboard
2. Replace the service processor
card.
Location: U0.1-P1-X1
AIX Location Code: 10-70 or
10-70 to 10-77 1E-xx
3. Replace the I/O planar.
Location: U0.1-P1
4. Go to “MAP 1540: Minimum
Configuration” on page 117.
Chapter 4. Checkpoints
149

IBM S85 pSeries 680 Specifications

General

Brand	IBM
Model	S85 pSeries 680
Category	Server
Language	English