IBM System x3300 M4

To Next Page

To Previous Page

Table 18. IMM2 error messages (continued)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is

solved.

v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained

technician.

806f0207-2584xxxx All CPUs / one of

the CPUs has failed

with FRB1/BIST

condition.

Error A Processor Failed

- FRB1/BIST

condition has been

detected.

1. Reseat the microprocessor, and then

restart the server.

2. Replace microprocessor n.

(n = microprocessor number)

806f030c-2581xxxx Scrub Failure for All

DIMMS / one of the

DIMMs on

subsystem.

Error A memory scrub

failure has been

detected.

1. Reseat the DIMM, and then restart

the server

2. Replace DIMM n.

(n = DIMM number)

806f0507-0301xxxx

806f0507-0302xxxx

806f0507-2584xxxx

The Processor CPU n

Status has a

Configuration

Mismatch. (n =

microprocessor

number)

Error A processor

configuration

mismatch has

occurred.

1. Check the CPU LED. See more

information about the CPU LED in

Light path diagnostics LEDs.

2. Check for a server firmware update.

Important: Some cluster solutions

require specific code levels or

coordinated code updates. If the

device is part of a cluster solution,

verify that the latest level of code is

supported for the cluster solution

before you update the code.

3. Make sure that the installed

microprocessors are compatible with

each other (see “Replacing a