EasyManuals Logo
Home>IBM>Server>System x3300 M4

IBM System x3300 M4 User Manual

IBM System x3300 M4
470 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #245 background imageLoading...
Page #245 background image
Table 18. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
40000081-00000000 PXE boot requested
by user [arg1].
Info PXE boot
requested.
No action; information only.
40000082-00000000 The measured power
value has returned
below the power cap
value.
Info Power exceeded
cap recovered.
No action; information only.
40000083-00000000 The new minimum
power cap value has
returned below the
power cap value.
Info Minimum Power
Cap exceeds Power
Cap recovered
No action; information only.
40000084-00000000 IMM firmware
mismatch between
nodes [arg1] and
[arg2]. Please
attempt to flash the
IMM firmware to the
same level on all
nodes.
Info A mismatch of
IMM firmware has
been detected
between nodes.
No action; information only.
40000085-00000000 FPGA firmware
mismatch between
nodes [arg1] and
[arg2]. Please
attempt to flash the
FPGA firmware to
the same level on all
nodes.
Error A mismatch of
FPGA firmware
has been detected
between nodes.
No action; information only.
40000086-00000000 Test Call Home
Generated by user
[arg1].
Info Test Call Home
generated by user.
No action; information only.
40000087-00000000 Manual Call Home
by user [arg1]:
[arg2].
Info Manual Call Home
by user.
No action; information only.
40000088-00000000 Management
Controller [arg1]:
Configuration
restoration from a
file by user [arg2]
completed.
Info This message is for
the use case where
a user restores a
Management
Controller
configuration from
a file and it
completes.
No action; information only.
40000089-00000000 Management
Controller [arg1]:
Configuration
restoration from a
file by user [arg2]
failed to complete.
Info This message is for
the use case where
a user restores a
Management
Controller
configuration from
a file and the
restoration fails to
complete.
No action; information only.
Chapter 4. Troubleshooting 227

Table of Contents

Other manuals for IBM System x3300 M4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM System x3300 M4 and is the answer not in the manual?

IBM System x3300 M4 Specifications

General IconGeneral
BrandIBM
ModelSystem x3300 M4
CategoryServer
LanguageEnglish

Related product manuals